This is the straight fitting head between the carbs not the angle fitting head. Angle fitting head is in another listing.
****NO DOMES IN THIS SALE**** use current style domes from Noss or anyone else.
CHARIOT BANSHEE DM & CHEETAH ONLY HEAD (does NOT fit stock or cub cylinders)
FINE MILLED BARE ALUMINUM FINISH!!!
- We addressed a severe flaw in the design of DM and Cheetah Heads.
- The center stud on a DM or Cheetah cylinder will not clamp down on two domes that are unequal thickness. No matter how close you try to get the domes cut we have never seen domes closer than .002" in difference. This is .002" of space in between the dome and cylinder which will never be clamped on. The thicker dome will be clamped on but not the thinner. The problem here is obvious. Look at most any DM or Cheetah cylinder and you will see after removing the head black ring past the oring at the center stud. This is because compression lifts the dome there and escapes. Our design solves this issue. Our center is a floating piece of thick aluminum which will clamp on two uneven domes on the center stud. PROBLEM SOLVED!
- Another problem addressed is the restriction inside the angle fitting from CP. If you look in the fitting you will see the casting for the bolt hole protrudes into the bore and blocks 20% or more of the flow. Ours does not.
Included in the sale is the head with all the fittings needed. This one has straight fitting on carb side. Orings are included for head and cylinder and domes. NO DOMES in this listing and NO nuts or washers. You can use Noss domes or any other dome that fits a DM Head. Old style cheetah domes from Trinity will NOT work.